Wago TOPJOB-S-Rail-Mount-Terminal-Blocks

www.wago.com

WAGO Rail-Mount Terminal Blocks TOPJOB® S

Both 2006‑8671 and 2006‑8661 Disconnect Terminal Blocks are specially designed for use in photovoltaic and wind power systems, where voltages exceeding 1,000 V (IEC) and 600 V (UL) occur (e.g., generator junction boxes). • Ideal for high voltages in renewable energy applications • Disconnect terminal blocks with two alternative dis connect options: with orange knife disconnect (2006‑8671) with orange disconnect plug (2006‑8661) • These 2006 Series terminal blocks are approved for 1,500 VDC (IEC) or 1,000 VDC (UL) and 30 A. • With a terminal block width of 15 mm, the maximum cross-section for solid and fine-stranded conductors is 10 mm² (AWG 8) and 6 mm² (AWG 10) for ferruled con ductors. • Equipped with two test slots • Compatible with through terminal blocks of the same profile and all other terminal blocks TOPJOB® S

1 Conductor range: 0.5 … 10 mm² “s+f-st”; Push-in termination: 2.5 … 10 mm² “s” and 2.5 … 6 mm² “insulated ferrules; 12 mm” Depending on the conductor characteristic, a conduc tor with a smaller cross section can also be inserted via push-in termination. 2 1000 VAC/DC = rated voltage 1500 VDC 12 kV = rated impulse voltage 3 = pollution degree Please observe the application notes: Marking, from page 266 Protective warning markers must be applied individ ually. Approvals and corresponding ratings, visit www.wago.com

Carrier terminal block with disconnect plug (2006‑8401) in operating position

Carrier terminal block with disconnect plug (2006‑8401) in parked position

Disconnect/test terminal block with knife disconnect (2006‑8671) in disconnect position

Commoning a 15 mm-wide terminal block via push-in type jumper bars: 1 to 3 (2006‑433) and 1 to 5 (2006‑435).

Cover (2006‑191) seals unused conductor entry.

Test slots on both terminal block sides allow for direct measurement.

Test slots on both terminal block sides allow for direct measurement.

Alternatively, measurement can also be performed using Connectors (2006‑511) from terminal block 1 to 2. Spacer modules (2006‑549) must be used to compensate for the 15 mm terminal block width.

WAGO Rail-Mount Terminal Blocks TOPJOB® S

113